New fittings for 33C control cables: ball joints, eye ends, fork ends, a pivot, clamps and shims, single and double mounting brackets, plus an SD pull handle and its bracket. Compare the thread, the end type and the hole spacing with your old part before you order.
These are the small parts that connect a 33C cable to the lever or to the engine. A worn ball joint or a loose clamp is often the reason a throttle or gear feels sloppy, even when the cable itself is still sound. Compare the fitting with the one you are replacing: the thread, the eye or fork, and the hole spacing on a bracket all have to match.
In this category you will find ball joints, eye and fork ends, a pivot, 33C clamps and shims, single and double mounting brackets, plus an SD pull handle and its bracket, for example ball joint PRE31799. The cables themselves are in control cables; engine stop cables are in stop cables.
33C is a common size of marine control cable, used for throttle and gear on many boats. These fittings are made for that cable type. They will not fit a different cable series without checking.
It can be. A worn joint or a clamp that has slipped changes the travel. Also check that the cable is not too short and that the lever on the engine can move through its full range.
If the dimensions match the 33C standard, the ends usually fit. Still compare your old part with the photos and the measurements on the product page before you order.