New engine stop cables for a manual engine stop. Universal cables from 2.10 m to 4.90 m, in steps of about 30 cm. Genuine Yanmar cables in 3 m, 4 m and 7 m for GM, HM and selected JH engines. Measure the old cable end to end and check the fittings before you order.
A stop cable runs from the stop handle to the stop lever on the injection pump or governor. If the inner cable sticks or the outer casing is cracked, the engine can be hard to stop, or the handle feels slack. Measure the old cable from end to end, and check the fittings at both ends, before you order.
The universal cables run from 2.10 m (PRE31507) to 4.90 m, in steps of about 30 cm. For Yanmar GM, HM and selected JH engines we also have genuine cables in 3 m, 4 m and 7 m, for example 104271-67550 (3 m). Throttle and shift cables, and the 33C ends and brackets, are in control cables and cable accessories.
Measure the complete cable, including the fittings, along its run. Do not measure only the visible part at the panel. If you are between two lengths, take the longer one and check that you can still route it without sharp bends.
Only if the length and the ends match your old cable. The genuine Yanmar cables are made for those engines. If the old part still shows a Yanmar number, use that number.
Not always. The lever on the pump can also stick, or the inner cable can have come off at one end. Check both ends and the lever before you replace the cable.