Engine mounts for Volvo Penta and Yanmar inboards and saildrives, from single mounts to complete sets. You'll find Ellebogen and original Volvo Penta mounts, saildrive mount kits, shims, base plates and levelling kits. Not sure which mount you need? Send us your engine model and the number on the old mount, and we'll help you choose.
Engine mounts carry the engine on its bed. The rubber takes up vibration and noise, and the adjustable studs let you line the engine up with the propeller shaft or saildrive. When mounts wear out, you feel it straight away: more vibration, more noise and extra load on the shaft, coupling and seals.
Check the mounts at least once a season. Replace them when the rubber is cracked, soft or swollen from oil or diesel, or when it has come loose from the metal. A knock when you shift into gear, more vibration than usual or an engine that sits lower than before are also clear signs. Replace the mounts as a set and check the shaft alignment afterwards.
Start with your engine model and how it's installed: with a reverse gear or a saildrive. Then compare the number on the old mount with the listing. Many Ellebogen mounts in this category name the Volvo Penta or Yanmar number they replace. Also check the type, size and stud thread, as the front and rear mounts on one engine are not always the same. Shims and levelling kits help you get the height right. Mounts for Yanmar engines are also in Yanmar engine mounts.
That depends on the engine model, the gearbox or saildrive and the mount type. Search for the number on your old mount or your engine model, or send us a photo.
Yes, many Ellebogen mounts here are listed as a replacement for a specific Volvo Penta or Yanmar number. Check that the number and the engine in the listing match yours.
In most cases, yes. If one mount is worn, the others usually aren't far behind, and mixing old and new mounts makes the alignment harder to get right.
Showing 1–12 of 60 results

New
4 in stock | Backorder available

New
2 in stock | Backorder available