Cables for throttle, gear shift and engine stop. The 33C push-pull cables (Morse type) go from 1.50 m to 15.00 m in steps of about 30 cm. Stop cables are here as aftermarket from 2.10 to 4.90 m, and as genuine Yanmar cables of 3, 4 and 7 metres. Fork ends, ball joints, clamps and mounting brackets are here too. Everything in this category is new.
A stiff or slipping throttle or gear cable is usually worn inside. The 33C push-pull cable is the common type on boats with a single-lever control, so it fits most installations. Measure your old cable end to end and order the same length, for example PRE3300C10 for 3.05 m. See control cables for all lengths.
For the stop cable, the genuine Yanmar cable 104271-67550 (3 m) suits the GM and HM series. The aftermarket stop cables cover other engines. Fork ends, ball joints, clamps and brackets are in cable accessories. Keep your old ends if they are still good; they often fit the new cable.
Take the old cable out and measure it end to end. If you are between two lengths, take the longer one. A few extra centimetres are easier to route than a cable that is too short.
33C is the standard type on most single-lever controls and on many engines and gearboxes. Check the end fittings on your old cable against the product photos.
No, ends and clamps are sold separately. You can often use the ends from your old cable again.
Showing 0–0 of 0 results