Hoses and Fittings for fuel, cooling water, seawater and exhaust, plus bronze and brass hose tails, elbows, valves, through-hull intakes and stainless hose clamps. Fuel hose in this range is listed to ISO 7840 A1. Measure the inside diameter of the old hose, and note whether it is for fuel, water or exhaust, before you compare the listing.
This category brings together marine hose and the fittings that join it: fuel hose, water hose, exhaust hose, bronze and brass tails and elbows, ball valves, through-hull water intakes, sea strainers and hose clamps. Use the type that matches the job. Fuel hose, water hose and exhaust hose are not interchangeable, even when the diameter looks the same.
For hose, start with the inside diameter and the use: fuel, water or exhaust. Fuel hose here is listed as ISO 7840 A1, the fire-resistant type used in engine compartments. For a fitting, note the thread size and whether it is male or female, and whether you need brass, dezincification-resistant brass or bronze. Compare those details with the old part, not only the overall shape.
Measure the old hose with a caliper if you can, and take the thread size off the old fitting. Then compare both with the listing. No old part left? Send us a photo and the diameter or thread size. For a quicker route, go to Fuel Hoses or Fittings.
No. Fuel hose must be a type listed for fuel, such as the ISO 7840 A1 hose in this category. Exhaust hose has to take heat and the wet exhaust. Use water hose only for water.
Use the inside diameter, which is the bore the water, fuel or gas flows through, not the outside of the hose. If the old hose is flattened, measure the fitting it sat on instead.
Bronze is the usual choice for fittings that sit in seawater, such as through-hull intakes. Brass is widely used for hose tails and adapters in the engine space; some tails here are also dezincification-resistant brass. Match the material to the job and to the old fitting.