Threaded fittings for water and fuel lines on board: hose tails, 90° elbows, tees, hex nipples and reducing bushes from 1/2" to 1". They come in plain brass, CR brass and marine bronze. There are also bronze through-hull intakes with grille, 3/8" ball valves and banjo kits for 8 and 10 mm fuel hose. All fittings are new.
Choose the material by where the fitting goes. Below the waterline, use bronze or CR brass. Plain brass can lose its zinc in seawater and go brittle, so keep that for lines above the waterline. A bronze 90° elbow like GS30651 (1/2" female/female) or a through-hull intake like GS30600 (1/2") is made for below the waterline.
Check the thread and size on your existing fitting before you order; the nominal size alone does not tell you everything. Hoses to go with these fittings are in water hoses and fuel hoses.
Plain brass is fine above the waterline. CR brass is corrosion-resistant brass and holds up better in water. Bronze is the strongest choice for through-hulls and anything below the waterline.
The hose size is in the product name, for example 1/2" thread x 17 mm hose. Secure the hose with a clamp of the right size.
Mixing metals below the waterline can cause corrosion. Keep to one material where you can, and check your anodes.